Hedges often look full from the footpath. Step closer and you'll see the bottom: thin foliage, bare stems and gaps you can see light through. It's a common hedge problem, and it's usually fixable.
The cause is almost always light, shape or care. Work through those three, and the base can fill in again.
What Causes a Bare Base
Light is the first suspect. Leaves need sun to stay healthy. When the top of a hedge is wider or denser than the base, it shades the lower growth. Those leaves yellow, thin and drop. The stems below are left with little to show.
Shape is the second. A hedge trimmed flat on top and straight down the sides, year after year, often ends up with a dense top and a starved bottom. The top takes all the light.
Neglect comes next. A hedge left untrimmed for several seasons grows leggy. New growth forms high up, where the light is, and the lower stems carry few leaves.
Water and soil matter too. Hedges planted near fences or under eaves miss out on rain. Lawn and tree roots compete for moisture, and hungry soil can leave a plant too weak to fill in. Look under the leaves and along the stems for pests or disease, too. Both can thin the base quickly.
Start With the Shape
Reshape the hedge so the top is narrower than the base. This taper, often called an A-shape, lets light reach the lower foliage. Slope the sides inward as they rise. Avoid a flat top that's wider than the bottom.
Make the change gradually. Trim a little at a time over the growing season. Don't cut the hedge back to a new profile in one go.
Cut Back Without Shocking the Plant
Don't remove more than about a third of the growth in one session. Heavy cutting stresses a plant and can invite pests. For a hedge that's badly bare, spread the renovation over two seasons.
Check what your plant can handle first. Many broadleaf hedges, including lilly pilly and box, reshoot from older wood. Conifers, such as Leyland cypress, usually won't regrow from bare brown wood. Cut those back only to green growth.
Save heavy cuts for the cooler months, just before spring growth starts. In the tropics, the late dry season suits this best. Avoid hard cuts in summer heat, when a stressed plant struggles to recover.
Use sharp, clean secateurs for thick stems and sharp hedge shears for the rest. Clean tools also stop disease spreading from one plant to the next.
Feed, Water and Mulch
A hard cut asks a lot of a plant. Support it afterwards.
Water deeply during dry spells. Aim the water at the root zone rather than the surface. Soaker hoses or a drip line work well along a hedge. Check the sections under eaves, because rain rarely reaches them.
In spring, spread a slow-release fertiliser suited to your plant, and follow the label. Then mulch around the base with 5 to 10 centimetres of organic material. Keep the mulch clear of the stems so the bark doesn't rot.
Give It Time, or Replace a Section
New shoots often appear within a few weeks of cutting in warm weather. Filling in can take a season or two, so be patient. Avoid cutting again until the plant has responded.
If a section is still bare after a full growing season, or the plant is old and tired, replace that section. New plants fill in far faster than old wood ever will. Choose a variety suited to your climate. Space it according to its mature width, so the gaps don't return.
Keep the Base Dense
Light trims through the growing season do more than hard cuts ever will. They keep the taper in place and the base thick, so a renovation is rarely needed. Many homeowners choose a regular garden maintenance routine for exactly this reason. The work is handled before the gaps appear.
A tapered, lightly trimmed hedge stays full from the ground up. Start with the shape, cut in the right season and keep the base in the light.
Written by Michael Mulcahy, owner-operator of Integrity Hedging & Gardens, a garden maintenance business in Perth's northern suburbs.